A&D OP-11 Instrukcja Instalacji Pobierz pdf (Strona 86)

2 Operating A&D DataManagement 07/2011

2.4 Specifying the properties of the control components

2-86 SIMATIC A&D DataManagement Client - 07/2011

Contents of the backup

Checkboxes NCU, loadable compile cycles, PLC and PROFIBUS drives are

used to define which components should be the contents of the backup of the

SINUMERIK components. Every component can be backed-up independently

of the others. A dedicated archive file is generated for each component of the

backup.

If the NC does not contain any compile cycles or drive data, but the appropriate

selection was made, the following applies:

• An alarm is only output to indicate that this component was not able to

be backed up if at least one additional component was successfully

backed up.

• If a partial backup is not possible, because e.g. only compile cycles are

selected, then the backup is exited with error.

• If an error other than "Data do not exist” occurs, then the backup is

always exited with an error.

Notice

If the M:N option is activated:

• The backup options "Loadable compile cycles” and "PROFIBUS drives"

are grayed out.

• If, during the backup, ADDM detects that the NC is an 840D sl, backup is

interrupted and an error message is output.

Option, Routing via agent

SINUMERIK can also be addressed via a computer with ADDM Agent in the

network using Routing via agent. To do this, the computer name or the TCP/IP

address of the Agent computer should be specified via which this component is

connected.

Notice

For "Routing via agent”, HMI Advanced is expected on the PCU 50!

Save only in the reset state

Caution

We recommend that data is only backed-up in the reset state. The reason for this

is that backups carried-out during production can result in data inconsistency!

This is the reason that the backup checkbox "Save only in the reset state" is set

as standard.

Max. no. of backups

The number of backups to be saved from ADDM is defined in the input field

"Max. no. of backups”. When saving, ADDM takes into account what has been

specified and saves a new backup separately. If the "Max. no. of backups” is

reached, data is saved in the oldest backup. This data is then overwritten. This

means up to a maximum of 99 backups can be backed-up in ADDM , also refer

to chapter 2.5.2.

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 181 182

Komentarze do niniejszej Instrukcji

Brak uwag

A&D OP-11 Instrukcja Instalacji Strona 86

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Pomiary, testowanie i kontrola A&D OP-11